3.7.5 Changing the brake fluid
WARNING
Racing Brake Fluid-325° (DOT 4) supplied by Performance Friction Brakes should be
used. Proceed as follows when changing the brake fluid.
Remove the brake fluid from the brake fluid reservoir of the two master
cylinders using a syringe.
Replenish new brake fluid.
Flushing/Bleeding
1.
Build up pressure with the brake pedal
2.
Open the front axle and rear axle brake bleeder valves simultaneously and close
them again
3.
Only release the brake pedal when the bleeder valves have been closed. Build up
new pressure with the brake pedal.
4.
Repeat the process and make sure that there is enough fluid in the reservoir.
5.
Perform flushing operation on both valves of a caliper (Order: inside then outside
and inside again)
It is recommended to bleed the system after every session and to change the brake
fluid after every race.
Version: 4/20/2018
Corrosive fluids
Danger of chemical burns
Wear personal protective equipment.
•
Ensure good ventilation.
•
Avoid contact with corrosive fluid.
•
If you do come into contact, wash off immediately
•
with plenty of warm water and contact a doctor if
necessary.
Chassis
911 GT3 Cup (991 II)
MY 2018
213