Porsche 911 GT3 Cup 2018 Techical Manual page 282

Consumable supplies
Rear carrier
3M 2C adhesive DP 490 (1 per side)
Mixing nozzle (1 per side)
Blind rivet 3.0-8.5 mm (0.12-0.33 inches) (55 pieces, instead of screws)
M5 Torx screw (55 pieces)
Preparation for removing the rear section
Remove bumpers
Remove drive unit
Removing the rear section
The standard bolts will be replaced by rivets.
Remove the Torx bolts from the carrier frame.
Fit the clamping claw to the carrier frame assembly and knock it loose from the
body.
Carry out grinding operations using a stainless steel wire brush. Always use special
grinding wheels for grinding aluminum. Use grinding wheels with grain size P80 to
P200. Observe corrosion protection measures.
Thoroughly remove paint from the glued joints (hatched).
4.15.3.4
Smooth any roughness on the lower rim that occurs during removal.
Version: 4/20/2018
Bodywork
911 GT3 Cup (991 II)
MY 2018
281