Porsche 911 GT3 Cup 2018 Techical Manual page 91

Powertrain
2.8.7.7
2.8.7.8
2.8.7.9
911 GT3 Cup (991 II)
90
Insert the cross shaft in tool no. 44. Ensure the correct seat of the two insert washers!
The insert washers are supported by the cylinder rolls of the bearing (Figure 2.8.7.7)
WARNING
Push the cage out of the cylinder roll bearing (cross shaft) with tool no. 44 (Figure
2.8.7.8)
Caution
Heat the cross shaft lid (1) at 130 °C (266 F) for 30 minutes
Take the outer ring of the cylinder roll bearing (2) out of the cross shaft lid (1)
(without applying great force)
MY 2018
Mechanical, hydraulic or pneumatic press
Risk of crush injuries
 Read specific safety information for the
press.
 Check that the press is working perfectly
before use, particularly the safety
components.
Hot components
Danger of burns
 Wear personal protective equipment.
Version: 4/20/2018