Table of Contents
Advertisement
The figure shows the saw line on the outer right side.
Bodywork
Cut the support frame using the power saw (saw blade 14) along the line (1). Starting
from the center of the oval cut-out, the cut must be made immediately behind the two
threads shown.
Use a hot air gun to heat up the bonding points that run along the areas where the
rivets have been drilled through.
The left side is shown in the figure, rear side of front section/support.
4.15.1.14
Drill out the five rivets (Figure 4.15.1.15).
Do not drill into the support.
Remove weld seam of support/front section (arrow).
Use a cutting chisel to separate the bonded joints of the sheets. If necessary, heat up
the bonded areas with a hot-air gun.
Remove weld seam of support/front section (Figure 4.15.1.16).
4.15.1.15
4.15.1.16
911 GT3 Cup (991 II)
Version: 4/20/2018
260
MY 2018
Advertisement
Table of Contents
