The alternation of the lead pump can take place at a command signal or at staging (adding lag pump). ® MI18I302 - VLT is a registered Danfoss trademark...
25-04 Pump *[0] Disabled *[0] Disabled Select the Cycling [1] Enabled method for the variable determining the speed pump. order of cutting in/out the fixed speed pumps. ® MI18I302 - VLT is a registered Danfoss trademark...
Page 5
Mode at [1] Quick minimum speed, Alternation a fixed speed 25-57 Relays The number of pump is per Pump relays used per destaged when pump. the programmed time expires. ® MI18I302 - VLT is a registered Danfoss trademark...
Page 6
53 or 54 and 55) make the frequency converter run. 0/4-20mA A OUT / DIG OUT 0/4-20mA A OUT / DIG OUT 12 20 55 COM A IN COM DIG IN Illustration 1.3 Control Terminals ® MI18I302 - VLT is a registered Danfoss trademark...
61 on 116,117 and 118 unites 24V (NPN) OV (PNP) (PNP)-Source (NPN)-Sink Illustration 1.4 Electrical Overview NOTE There is no access to UDC- and UDC+ on the following units: IP20 380-480 V, 30-90 kW ® MI18I302 - VLT is a registered Danfoss trademark...
Need help?
Do you have a question about the VLT HVAC Basic Drive and is the answer not in the manual?
Questions and answers