Lucent Technologies CBX 3500 Configuration Manual page 690

Configuring SPVCs
Defining a Point-to-Point Offnet Circuit Connection
6. After defining non-Lucent nodes, click Lucent Node to define the next hop to a
7. Choose OK when you have defined the path.
8. In the Path tab, select (enable) or clear (disable) the Use Defined Path check box
9. Enable or disable the Alternate Path check box to specify whether OSPF should
10. In the Add OffNet Circuit dialog box, choose OK to add or modify the circuit
18-261/19/05
Lucent switch, entering the internal IP Address of the next Lucent switch node
and optional logical port interface ID.
Navis EMS-CBGX adds the path to the Defined Path section when the path is
complete.
to specify whether to use the defined path or to enable the network routing to
specify the circuit path.
• Check box selected (Enabled) – Routes the circuit based on the manually
defined route.
• Check box cleared (Disabled) – Routes the circuit based on the network's
OSPF algorithm.
route the circuit path if the manual route fails.
• Yes – Enables OSPF to route the circuit based on the best available path if the
manually defined path fails.
• No – Prevents the circuit from being rerouted; the circuit remains down until
the defined path is available.
when your configuration is complete.
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Beta Draft Confidential