Lucent Technologies CBX 3500 Configuration Manual page 599

Beta Draft Confidential
Table 17-1. Configure SVC: General Tab Fields (Continued)
Priorities
QoS Class
Bandwidth (0-15)
Bumping
Restricted Priority
Routing
Admin (0-7)
Forward
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Field
The four available QoS classes are listed in this column:
• CBR
• VBR RT
• VBR NRT
• UBR/ABR
For each QoS class, specify a value from zero (0) through 15, where
8 is the default and zero (0) indicates the highest priority.
See Appendix E, "Priority Routing,"
If restricted priority routing is disabled, clear the check box (default)
to keep non-real time SVCs originating at this logical port in retry
mode until sufficient bandwidth is available.
Select the check box for non-real time SVCs to become active,
whether or not sufficient bandwidth exists.
If restricted priority is enabled, non-real time circuits that are
bumped remain in retry mode until sufficient bandwidth is available,
regardless of the bumping eligibility setting (disabled or enabled).
Bumping eligibility is valid only for non-real time circuits, based on
QoS classes. Real-time circuits ignore this setting.
See Appendix E, "Priority Routing,"
Select the check box (default) to provision new SVCs at the lowest
bandwidth priority, regardless of configured higher bandwidth
priority and bumping eligibility settings.
Clear the check box if you want to use the configured bandwidth
priority and bumping eligibility settings for newly provisioned
circuits.
See Appendix E, "Priority Routing"
Not applicable.
Choose one of the buttons to set the discard priority for the SVC in
the forward direction (the caller to callee direction of an SVC).
When a particular service category's output queue becomes
congested, it must discard cells. The lower the number, the higher the
priority. Set this attribute from 1 (high priority) to 3 (low priority).
The default is 2.
Configuring SVC Parameters
Configuring SVC Attributes
Action/Description
for more information.
for more information.
for more information.
1/19/0517-7