Table 8-8. Add Logical Port: Ilmi/Oam Tab - Lucent Technologies CBX 3500 Configuration Manual

Beta Draft Confidential
For ATMoMPLS UNI/NNI feeder logical ports, you can configure the fields in the
ILMI/OAM tab as described in

Table 8-8. Add Logical Port: ILMI/OAM Tab

Enable
VPI Id (0-15)
VCI Id (0-1023)
Loss Threshold (K)
Polling Period (sec)
Forward: Select
Reverse: Select
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Table
Field
Select the check box to reserve a percentage of bandwidth in
the VBR-NRT QoS class for ILMI.
Clear the check box (default) to disable ILMI and not have
reserve bandwidth. If the attached device cannot run ILMI,
leave ILMI disabled.
Note: To use line loopback diagnostics, you must disable ILMI
support.
Enter the ID of the VPI you want to use for ILMI polling.
The default value is zero (0).
Enter the ID of the VCI you want to used for ILMI polling.
The default value is 16.
Enter a value for the number of times (K) the logical port will
issue an ILMI poll before the link is considered down. If no
responses are seen in K x T seconds, the link is considered
down. The default value is 4.
Enter the interval for the polling period (T). The switch
generates an ILMI poll every T seconds.
The default is 5 seconds.
Accesses the ILMI Forward/Reverse Traffic Descriptor dialog
box. This option enables you to modify the traffic
characteristics for the control channel. This feature is known as
configurable control channel. See
Attributes" on page 3-41
box.
Configuring ATM Over MPLS Trunks
Configuring Feeder Logical Ports
8-8.
Action/Description
"Traffic Descriptor
to complete the fields on this dialog
1/19/058-31