Lucent Technologies CBX 3500 Configuration Manual page 484

Configuring ATM PVCs
Manually Defining the Circuit Path
6. Enter the 22-byte PNNI node ID and optional interface ID identifying other
7. Click on the Add to Path button to save the path name and return to the Define
8. After defining non-Lucent nodes, click on the Lucent Node button to define the
9. Click on the Add to Path button to save the path name and return to the Define
10. Choose OK in the Define Path dialog box when you have defined the path. The
11. Select the Path tab.
12. Select (enable) or clear (disable) the Use Defined Path check box to specify
13. Select the Alternate Path check box to specify whether OSPF should route the
14. In the Add/Modify PVC dialog box, choose OK to save the PVC configuration.
10-701/19/05
vendor equipment.
Path dialog box.
next hop to a Lucent switch, entering the internal IP Address of the next Lucent
switch node and optional logical port interface ID.
Path dialog box.
Navis EMS-CBGX adds the path to the Defined Path section when the path is
complete.
Add PVC dialog box appears.
whether to use the defined path or to enable the network routing to specify the
circuit path.
• Enabled (check box selected) – Routes the circuit based on the manually
defined route.
• Disabled (check box cleared) – Routes the circuit based on the network's
OSPF algorithm.
circuit path if the manual route fails.
• Enabled (check box selected) – Enables OSPF to route the circuit based on the
best available path if the manually defined path fails.
• Disabled (check box cleared) – Prevents the circuit from being rerouted; the
circuit remains down until the defined path is available.
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Beta Draft Confidential