Lucent Technologies CBX 3500 Configuration Manual page 478

Configuring ATM PVCs
Configuring Frame Relay-to-ATM Interworking Circuits
Table 10-13. Add PVC: User Preference Tab Fields (Continued)
Bulk Statistics
Frame Relay to ATM Parameters
Translation Type
(ATM endpoint
only)
Cell Loss Priority
(ATM endpoint
only)
Discard Eligibility
(ATM endpoint
only)
10-641/19/05
Field
Select the check box to enable Bulk Statistics to configure statistics
collection from a circuit using the NavisXtend Statistics Server.
The default is disabled (check box cleared).
Note: If you enable Bulk Statistics at the circuit level, the change
does not take effect unless you first enable Bulk Statistics at the
Switch, Card, and LPort levels.
For information about using the feature, see the NavisXtend
Statistics Server User's Guide.
Select the ATM Translation Type protocol. Options include:
None – Each end of the circuit uses the 1490 protocol.
RFC 1490 ⇔ 1483 – This value is the default if you have a Frame
Relay logical port on endpoint 1 and an ATM logical port on
endpoint 2.
RFC 1483 ⇔ 1490 – This option is the default if you have an ATM
logical port on endpoint 1 and a Frame Relay logical port on
endpoint 2.
Specify the CLP setting. The CLP bit is in each cell's header.
Options include:
0 – Sets the CLP bit to zero (0).
1 – Sets the CLP bit to 1.
fr-de (
OC-3c/STM-1
as the Frame Relay frame DE bit on all ATM cells. This maps the
DE bit to CLP.
For more information about configuring this parameter for FRF.5,
see "Special Network Interworking PVC Configuration
Parameters" on page
Select one of the following options:
0 – Sets the DE to zero (0).
1 – Sets the DE to 1.
atm clp (
OC-3c/STM-1
cell of the frame to Frame Relay frame DE bit.
For more information about configuring this parameter for FRF.5,
see "Special Network Interworking PVC Configuration
Parameters" on page
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Beta Draft Confidential
Action/Description
1-port ATM CS DS3/E3
modules only) – Sets the CLP bit to the same value
10-42.
1-port ATM CS DS3/E3
modules only) – Sets the CLP bit received in last
10-42.
1-port ATM IWU
and
1-port ATM IWU
and