Layer 2 Tunnel Pnni Attributes - Lucent Technologies CBX 3500 Configuration Manual

Configuring ATM Over MPLS Gateway Solution on CBX 3500
Configuring a Layer 2 Tunnel Over MPLS Core Network
Table 9-23. Add Layer 2 Tunnel: VNN Tab Fields (Continued)
State Hold Down Timer
Enable IP Routing
IP Area
IP Cost (0-max)

Layer 2 Tunnel PNNI Attributes

If this tunnel is being configured for PNNI, select the PNNI tab
complete the fields as described in
Figure 9-28. Add Layer2 Tunnel: PNNI Tab
9-581/19/05
Field
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Beta Draft Confidential
Description
Not supported in this release.
Enable IP routing for the trunk by selecting the check box. If
disabled (unchecked), the trunk is reserved for use by VNN.
Also activates the Trunk IP Area ID and Type of Service
(ToS) Zero Metric fields. See the IP Services Configuration
Guide for CBX 3500, CBX 500, and B-STDX 9000 for more
information.
The OSPF Area ID used by IP Services. See the IP Services
Configuration Guide for CBX 3500, CBX 500, and
B-STDX 9000 for more information.
Enter a value between 0 and 65535 (the default value is 100).
This value specifies the IP cost. The lowest cost has the
highest priority for routing.
Table 9-24.
(Figure 9-28) and