Lucent Technologies CBX 3500 Configuration Manual page 429

Beta Draft Confidential
5. Verify the information in the Select Endpoints dialog box to ensure the correct
6. Choose OK to return to the Add PVC dialog box, which now displays the
7. Continue with one of the following sections, according to the ATM service you
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
You can configure a fault-tolerant PVC connection only for the following
ATM logical port types:
– UNI DCE
– UNI DTE
b. Continue with step
For a RLMI PVC Connection
a. Expand the Service Names node, and select a service name from the list.
You can configure an RLMI PVC only for the following logical port types:
– UNI DCE, UNI DTE, NNI (see the Frame Relay Services Configuration
Guide
for CBX 3500, CBX 500, and B-STDX 9000
– ATM network interworking for Frame Relay NNI
b. Continue with step
For a PWE3 Circuit Configuration
a. Expand the Switches node, select a switch, and use the Cards or LPorts node
to select Endpoint 1. The endpoints must be configured for PWE3.
b. Repeat step a to select the name of the logical port for Endpoint 2.
c. Continue with step
endpoints have been selected.
information for the selected Endpoint 1 and Endpoint 2 Logical Ports.
are configuring:
• If both endpoints provide ATM services, continue with the following section,
"About the PVC Tabs" on page
• If one endpoint provides Frame Relay services, continue with
Frame Relay-to-ATM Interworking Circuits" on page
• If both endpoints provide ATM services and you plan to enable PWE3
signalling, continue with
page 10-68.
Defining a Point-to-Point Circuit Connection
5.
5.
5.
10-16.
"Manually Defining the Circuit Path" on
Configuring ATM PVCs
)
"Configuring
10-40.
1/19/0510-15