Beta Draft Confidential
Configuring ATM PVCs
This chapter describes how to configure the following types of Lucent ATM
permanent virtual circuits (PVCs):
•
Point-to-point
•
Frame Relay-to-ATM Service/Network Interworking
•
Redirect
•
Point-to-multipoint (PMP)
In addition, this chapter explains how to manually define PVCs and use the Move
Circuit function.
See
Chapter 11, "Configuring Management Paths"
PVCs, management SPVCs, and management redirect PVCs.
Note – For information about the virtual circuit (VC) capacity for various elements on
a B-STDX, CBX, or GX switch, see the appropriate Switch Software Release Notice
(SRN).
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
(page
10-13)
(page
10-34)
(page
10-71)
(page
10-40)
for information about management
10
10-1