The following entries are displayed on this screen:
Uvcvke"Ownvkecuv"Eqphki"
"
XNCP"KF<"
Ownvkecuv"KR<"
Ogodgt"Rqtvu<"
Uvcvke"Ownvkecuv"Nkuv"
"
Ugngev<"
XNCP"KF<"
Ownvkecuv"KR<"
Ogodgt"Rqtvu<"
320408" Swgtkgt"Eqphki"
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
to create and maintain multicast forwarding table on the switch with the Query messages it
generates.
Choose the menu Ownvkecuv→ONF"Upqqrkpi→Swgtkgt"Eqphki to load the following page.
Figure 10-18 Static Multicast"
Enter the VLAN ID.
Enter the multicast IP address.
Enter the member ports of the static multicast group.
Select the static multicast group you want to change.
Displays the VLAN ID.
Displays the multicast group IP address.
Displays the member ports of the static multicast
group.
Figure 10-19 Querier Config
160
Need help?
Do you have a question about the TL-SL5428E and is the answer not in the manual?