TP-Link TL-SL5428E User Manual page 138

2. The unidirectional link should be disconnected once being detected, and the ports shut down
by DLDP can be restored after the fiber pairs are correctly connected.
Pgvyqtm"Fkcitco"
"
Eqphkiwtcvkqp"Rtqegfwtg"
"
Uvgr" Qrgtcvkqp"
1 Enable DLDP globally.
2 Enable DLDP on the
specified ports.
3 Configure Shut Mode.
4 Check the ports' state.
The DLDP information of Gigabit Ethernet ports 1/0/27 and 1/0/28 is shown below:
Figure 8-13 DLDP Application Example
Fguetkrvkqp"
Required. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure DLDP State as enable under the Global Config
tab in device A and B.
Required. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure DLDP State as enable on Gigabit Ethernet ports
1/0/27 and 1/0/28 in the Port Config table in device A and
device B.
Required. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure the Shut Mode as auto under the Global Config
tab in device A and B.
Required. On the Gvjgtpgv"QCO→FNFR→FNFR page,
select ports 1/0/27 and 1/0/28 in the Port Config table and
click the Tgugv"button to bring them up.
126