Static Multicast; Querier Config - TP-Link JetStream TL-SG3424 User Manual

Filter IDs:
Max Groups:
LAG:
Note:
1. If the Max Groups value is set less than the current value, some groups may be deleted to
satisfy the restriction.
2. The max number of filter entries on each port is 15.

8.2.5 Static Multicast

On this page you can configure static multicast groups. The multicast groups configured here are
not learned by MLD Snooping and independent of dynamic multicast groups and multicast filters.
The static multicast member ports won't age out.
Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
The following entries are displayed on this screen:
Static Multicast Config

VLAN ID:
Multicast IP:
Member Ports:
Static Multicast List

Select:
VLAN ID:
Multicast IP:
Member Ports:

8.2.6 Querier Config

In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
Enter the filter IDs with this port. The filter IDs are
configured in Filer Config. The format is 1,4,12.
Enter the maximum groups which the port can join as
the member port. It ranges from 0 to 256.
Displays the LAG number.
Enter the VLAN ID.
Enter the multicast IP address.
Enter the member ports of the static multicast group.
Select the static multicast group you want to change.
Displays the VLAN ID.
Displays the multicast group IP address.
Displays the member ports of the static multicast
group.
128