Traps Config - TP-Link TL-SL5428E User Manual
24-port 10/100mbps + 4-port gigabit jetstream l2 managed switch
Hide thumbs
Also See for TL-SL5428E:
- Reference manual (341 pages) ,
- Cli reference manual (320 pages) ,
- User manual (250 pages)
Table of Contents
Advertisement
The following entries are displayed on this screen:
UPOR"Vtcru"
"
UPOR"
Cwvjgpvkecvkqp<"
Eqnfuvctv<"
Yctouvctv<"
Nkpm"Uvcvwu<"
ERW"Wvknk|cvkqp<"
Ogoqt{"Wvknk|cvkqp<"
Hncuj"Qrgtcvkqp<"
Figure 14-9 Traps Config
If selected, the switch will send an SNMP Authentication trap
when a received SNMP request fails the authentication.
If selected, the switch will send a Coldstart trap when it is rebooted
with the SNMP function enabled.
If selected, the switch will send a Warmstart trap when you enable
the SNMP function.
If selected, the switch will send a Link Status trap when the
up/down status of the port changes.
If selected, the switch will send a CPU Utilization trap when the
CPU utilization rate is over 80%.
If selected, the switch will send a Memory Utilization trap when the
memory utilization rate is over 80%.
If selected, the switch will send a Flash Operation trap when a
flash operation occurs. The flash operations include firmware
upgrading, system resetting, config restoring and config saving.
245
Advertisement
Table of Contents
Need help?
Do you have a question about the TL-SL5428E and is the answer not in the manual?