Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
The following entries are displayed on this screen:
Static Multicast Config
VLAN ID:
Multicast IP:
Member Ports:
Static Multicast List
Select:
VLAN ID:
Multicast IP:
Member Ports:
8.2.6 Querier Config
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
to create and maintain multicast forwarding table on the switch with the Query messages it
generates.
Choose the menu Multicast→MLD Snooping→Querier Config to load the following page.
Enter the VLAN ID.
Enter the multicast IP address.
Enter the member ports of the static multicast group.
Select the static multicast group you want to change.
Displays the VLAN ID.
Displays the multicast group IP address.
Displays the member ports of the static multicast
group.
133