Lacp Config - TP-Link TL-SL5428E User Manual

Choose the menu Uykvejkpi→NCI→NCER"Eqphki to load the following page.
The following entries are displayed on this screen:
Inqdcn"Eqphki"
"
U{uvgo"Rtkqtkv{<"
NCER"Eqphki"
"
Rqtv"Ugngev<"
Ugngev<"
Rqtv<"
Cfokp"Mg{<"
Rqtv"Rtkqtkv{<"
Figure 5-9 LACP Config
Specify the system priority for the switch. The system priority and
MAC address constitute the system identification (ID). A lower system
priority value indicates a higher system priority. When exchanging
information between systems, the system with higher priority
determines which link aggregation a link belongs to, and the system
with lower priority adds the proper links to the link aggregation
according to the selection of its partner.
Click the Ugngev"button to quick-select the corresponding port based
on the port number you entered.
Select the desired port for LACP configuration. It is multi-optional.
Displays the port number.
Specify an Admin Key for the port. The member ports in a dynamic
aggregation group must have the same Admin Key.
Specify a Port Priority for the port. This value determines the priority
of the port to be selected as the dynamic aggregation group
member. The port with smaller Port Priority will be considered as the
preferred one. If the two port priorities are equal; the port with
smaller port number is preferred.
49