Ntdp Config - TP-Link TL-SL5428E User Manual
24-port 10/100mbps + 4-port gigabit jetstream l2 managed switch
Hide thumbs
Also See for TL-SL5428E:
- Reference manual (341 pages) ,
- Cli reference manual (320 pages) ,
- User manual (250 pages)
Table of Contents
Advertisement
380405" PVFR"Eqphki"
On this page you can configure NTDP globally.
Choose the menu Enwuvgt→PVFR→PVFR"Eqphki"to load the following page.
The following entries are displayed on this screen:
Inqdcn"Eqphki"
"
PVFR<" "
PVFR"Kpvgtxcn"Vkog<"
PVFR"Jqru<"
PVFR"Jqr"Fgnc{<"
PVFR"Rqtv"Fgnc{<"
Figure 16-8 NTDP Config
Enable/Disable NTDP for the switch globally.
Enter the interval to collect topology information. The default is 1
minute.
Enter the hop count the switch topology collects. The default is 3
hops.
Enter the time between the switch receiving NTDP request
packets and the switch forwarding NTDP request packets for the
first time. The default is 200 milliseconds.
Enter the time between the port forwarding NTDP request packets
and its adjacent port forwarding NTDP request packets over. The
default is 20 milliseconds.
270
Advertisement
Table of Contents
Need help?
Do you have a question about the TL-SL5428E and is the answer not in the manual?