TP-Link TL-SL5428E User Manual page 258

XNCP"Etgcvg1Fgngvg"
KR"Ejcpig<"
Uvqto"Eqpvtqn<"
Dcpfykfvj"Eqpvtqn<"
NNFR<"
OCE"Cfftguu"Vcdng<"
Nqqrdcem"Fgvgevkqp<"
Urcppkpi"Vtgg<"
Rqtv"Ceeguu<"
KR/OCE"Dkpfkpi<"
KR"Fwrnkecvg<"
FJER"Hknvgt<"
Rqtv"Vtcru"
"
Rqtv"Ugngev<"
Ugngev<"
Rqtv<"
Nkpm"Uvcvwu<"
Pqvg<"
To enable the Link Status traps for the desired port, please select the "Link Status" on the UPOR"
Vtcru"first, otherwise, it will not take effect.
If selected, the switch will send a VLAN Create/Delete trap when a
VLAN is being created or deleted.
If selected, the switch will send an IP Change trap when the IP
address of the switch is changed.
If selected, the switch will send a Storm Control trap when the
broadcast, multicast or UL rate exceeds the limit. You can
configure the limit on SqU→Dcpfykfvj" Eqpvtqn" →Uvqto"
Eqpvtqn"page.
If selected, the switch will send a Bandwidth Control trap when the
traffic rate of a port exceeds the limit. You can configure the limit
on SqU→Dcpfykfvj"Eqpvtqn→Tcvg"nkokv"page.
If selected, the switch will send an LLDP trap when the status of
LLDP changes.
If selected, the switch will send a MAC Address Table trap when
the MAC address table has any changes.
If selected, the switch will send a Loopback Detection trap when
the status of loopback detection changes.
If selected, the switch will send a Spanning Tree trap when the
status of STP on the port changes.
If selected, the switch will send a Port Access trap when some
users try to log on to the web management page via ports
that have no authority. You can configure the access control policy
on U{uvgo→Ceeguu"Ugewtkv{→Ceeguu"Eqpvtqn"page.
If selected, the switch will send an IP-MAC Binding trap when it
receives a packet from the host that does not match the rules in
IP-MAC binding table. You can configure the IP-MAC Binding
policy on Pgvyqtm"Ugewtkv{→KR/OCE"Dkpfkpi"page.
If selected, the switch will send an IP Duplicate trap when another
host uses the switch's IP address.
If selected, the switch will send a DHCP Filter trap when it
receives a DHCP packet from an untrusted port.
Click the Ugngev" button to quick-select the corresponding port
based on the port number you entered.
Select your desired port for configuration. It is multi-optional.
Displays the port number.
Enable/Disable Link Status traps for the desired port.
246