General Setup Page - AudioCodes Mediant 1000B User Manual

User's Manual
48.2

General Setup Page

The General Setup wizard page defines the network topology of the device, which includes
the application (e.g., SIP trunk) and the involved third-party vendors, configuration template
based on the selected vendor interoperability, and physical network (ports). The wizard
displays an illustration of the basic architecture according to your chosen setup.
Figure 48-2: SBC Configuration Wizard - General Setup Page

To define the general setup:
1. Select one of the following 'Application' options:
•
SIP Trunk (IP-PBX with SIP Trunk): The device connects the Enterprise IP PBX
with the Internet Telephony Service Provider (ITSP) or SIP Trunk Provider. The
IP PBX resides on the Enterprise LAN, while the ITSP resides on the WAN. Only
calls between the IP PBX and ITSP traverse the device. Calls between Enterprise
phones, users and certain SIP messages (REGISTER, SUBSCRIBE and
NOTIFY) are managed locally by the IP PBX and do not traverse the device.
•
SIP Normalization (two IP-PBX's): The device performs SIP "normalization" of
traffic between two IP PBXs. The first IP PBX resides on the Enterprise LAN (co-
located with the device) and the second IP PBX resides on the WAN (or at
another branch site). Only calls between the IP PBXs traverse the device. Calls
between the phones and users of the same IP PBX, and certain SIP messages
(REGISTER, SUBSCRIBE and NOTIFY) are managed locally by each IP PBX
and do not traverse the device.
•
Hosted IP-PBX (IP-PBX with Users): The device connects phones (users) with
the "hosted" IP PBX. The users reside on the Enterprise LAN (co-located with the
device) and the IP PBX resides on the WAN (or at the datacenter). All traffic
between users and IP PBX traverse the device, including SIP REGISTER,
SUBSCRIBE and NOTIFY messages.
•
Remote Users (IP-PBX with Remote Users): The device connects remote
phones (users) with the "local" IP PBX. The IP PBX resides on the Enterprise
LAN (co-located with the device) and the remote users reside on the WAN (or at
the datacenter). All traffic between users and IP PBX traverse the device,
including SIP REGISTER, SUBSCRIBE and NOTIFY messages.
2. If you selected the SIP Trunk application in Step 1, do the following:
a. From the 'IP-PBX' drop-down list, select the IP PBX model. If the model is not
listed, select Generic IP-PBX.
Version 7.2 851 Mediant 1000B Gateway & E-SBC
48. SBC Configuration Wizard