AudioCodes Mediant 1000B User Manual page 460

handling by the device. For example, if specific channels require the use of the G.711
coder, you can configure a Tel Profile with this coder and assign it to these channels.
To use your Tel Profile for specific calls, you need to assign it to specific channels (trunks)
in the Trunk Group table (see Configuring Trunk Groups on page 503)).
The following procedure describes how to configure Tel Profiles through the Web interface.
You can also configure it through ini file (TelProfile) or CLI (configure voip/coders-and-
profiles tel-profile).

To configure a Tel Profile:
1. Open the Tel Profiles table (Setup menu > Signaling & Media tab > Coders &
Profiles folder > Tel Profiles).
2. Click New; the following dialog box appears:
3. Configure a Tel Profile according to the parameters described in the table below. For a
description of each parameter, refer to the corresponding "global" parameter.
4. Click Apply.
Table 20-6: Tel Profile Table Parameters and Corresponding Global Parameters
Tel Profile Parameter
General
Index
[TelProfile_Index]
Name
profile-name
[TelProfile_ProfileName]
Signaling
Profile Preference
tel-preference
[TelProfile_TelPreference]
User's Manual
Figure 20-7: Tel Profiles Table - Add Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines a descriptive name, which is used when associating the row in other
tables.
The valid value is a string of up to 40 characters.
Defines the priority of the Tel Profile, where 1 is the lowest priority and 20 the
highest priority.
Note:

If both the IP Profile and Tel Profile apply to the same call, the
coders and common parameters of the Preferred profile are
applied to the call.

If the Preference of the Tel Profile and IP Profile are identical,
the Tel Profile parameters are applied.
Mediant 1000B Gateway & E-SBC
Global Parameter
460 Document #: LTRT-27055