AudioCodes Mediant 1000B User Manual page 509

User's Manual
Parameter
Used By Routing Server
used-by-routing-server
[TrunkGroupSettings_UsedByR
outingServer]
SIP Configuration
Gateway Name
gateway-name
[TrunkGroupSettings_Gateway
Name]
Contact User
contact-user
[TrunkGroupSettings_ContactU
ser]
Serving IP Group
serving-ip-group
[TrunkGroupSettings_ServingIP
GroupName]
Version 7.2
The "SipGroupName" in the Request-URI is configured in the IP
Groups table (see ''Configuring IP Groups'' on page 353).
Note:

If the parameter is not configured, the registration is performed
according to the global registration parameter,
ChannelSelectMode.

To enable Trunk Group registration, set the global parameter,
IsRegisterNeeded to 1. This is unnecessary for 'Per Account'
registration mode.

If the device is configured globally to register Per Endpoint and
an channel group includes four channels to register Per
Gateway, the device registers all channels except the first four
channels. The group of these four channels sends a single
registration request.
Enables the use of the Trunk Group by a routing server for routing
decisions.

[0] Not Used (default)

[1] Used
For more information, see Centralized Third-Party Routing Server
on page 279.
Defines the host name for the SIP From header in INVITE
messages, and the From and To headers in REGISTER requests.
By default, no value is defined.
Note: If the parameter is not configured, the global parameter,
SIPGatewayName is used.
Defines the user part for the SIP Contact URI in INVITE messages,
and the From, To, and Contact headers in REGISTER requests.
By default, no value is defined.
Note:

The parameter is applicable only if the 'Registration Mode'
parameter is configured to Per Account and registration based
on the Accounts table is successful.

If registration fails, the user part in the INVITE Contact header is
set to the source party number.

The 'Contact User' parameter in the Accounts table overrides
this parameter (see ''Configuring Registration Accounts'' on
page 383).
Assigns an IP Group to where the device sends INVITE messages
for calls received from the Trunk Group. The actual destination to
where the INVITE messages are sent is according to the Proxy Set
associated with the IP Group. The Request-URI host name in the
INVITE and REGISTER messages (except for 'Per Account'
registration modes) is set to the value of the 'SIP Group Name'
parameter configured in the IP Groups table (see ''Configuring IP
Groups'' on page 353).
Note:

If the parameter is not configured, the INVITE messages are
509
Description
Mediant 1000B Gateway & E-SBC
23. Trunk Groups