AudioCodes Mediant 1000B User Manual page 1202

Parameter
gen-mtr-tones
[PayPhoneMeteringMode]
Analog Metering Type
configure voip > interface
fxs-fxo > metering-type
[MeteringType]
Analog TTX Voltage
Level
[AnalogTTXVoltageLevel
]
Charge Codes Table
User's Manual

[1] Table Code Table = Metering tones are generated by the device
according to the Charge Code table (see Configuring Charge Codes
on page 610) and sent to the Tel side.

[2] SIP Interval Provided = (Proprietary method of TELES
Communications Corporation) Advice-of-Charge service toward the
PSTN. Periodic generation of AOC-D and AOC-E toward the PSTN.
Calculation is based on seconds. The time interval is calculated
according to the scale and tariff provided in the proprietary formatted
file included in SIP INFO messages, which is always sent before 200
0K. The device ignores tariffs sent after the call is established.
(Applicable only to digital interfaces.)

[3] SIP RAW Data Provided = (Proprietary method of Cirpack) Advice-
of-Charge service toward the PSTN. The received AOC-D messages
contain a subtotal. When receiving AOC-D in raw format, provided in
the header of SIP INFO messages, the device parses AOC-D raw
data to obtain the number of units. This number is sent in the Facility
message with AOC-D. In addition, the device stores the latest number
of units in order to send them in AOC-E IE when the call is
disconnected. (Applicable only to digital interfaces.)

[4] SIP RAW Data Incremental Provided = (Proprietary method of
Cirpack) Advice-of-Charge service toward the PSTN. The AOC-D
message in the payload is an increment. When receiving AOC-D in
raw format, provided in the header of SIP INFO messages, the device
parses AOC-D raw data to obtain the number of units. This number is
sent in the Facility message with AOC-D. The device generates the
AOC-E. Parsing every AOC-D received and summing the values is
required to obtain the total sum (that is placed in the AOC-E).
(Applicable only to digital interfaces.)

[5] SIP-to-Tel Interworking = Enables IP-to-Tel AOC, using
AudioCodes' proprietary SIP header, AOC. (Applicable only to digital
interfaces.)
Note: The parameter is applicable only to FXS and ISDN Euro trunks for
sending AOC Facility messages (see Advice of Charge Services for Euro
ISDN on page 609).
Defines the metering method for generating pulses (sinusoidal metering
burst frequency) by the FXS port.

[0] 12 KHz sinusoidal bursts (default)

[1] 16 kHz sinusoidal bursts

[2] Polarity Reversal pulses
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.
Determines the metering signal/pulse voltage level (TTX).

[0] 0V = 0 Vrms sinusoidal bursts.

[1] 0.5V = (Default) 0.5 Vrms sinusoidal bursts.

[2] 1V = 1 Vrms sinusoidal bursts
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.
1202
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055