AudioCodes Mediant 1000B User Manual page 1227

User's Manual
Parameter
ber]
[CopyDestOnEmptySource]
Add NPI and TON to Calling
Number
configure voip > gateway
routing settings > npi-n-ton-to-
cng-nb
[AddNPIandTON2CallingNumb
er]
Add NPI and TON to Called
Number
configure voip > gateway
routing settings > npi-n-ton-to-
cld-nb
[AddNPIandTON2CalledNumbe
r]
Add NPI and TON to Redirect
Number
np-n-ton-2-redirnb
[AddNPIandTON2RedirectNum
ber]
IP to Tel Remove Routing Table
Prefix
configure voip > gateway
routing settings > ip2tel-rmv-rte-
tbl
[RemovePrefix]
Version 7.2
called number is missing.

The parameter is applicable only to digital interfaces.
Determines whether the destination number is copied to the source
number if no source number is present, for Tel-to-IP calls.

[0] = (Default) Source Number is left empty.

[1] = If the Source Number of a Tel-to-IP call is empty, the
Destination Number is copied to the Source Number.
Note: The parameter is applicable only to digital interfaces.
Determines whether the Numbering Plan Indicator (NPI) and Type
of Numbering (TON) are added to the Calling Number for Tel-to-IP
calls.

[0] No = (Default) Do not change the Calling Number.

[1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-
IP call.
For example: After receiving a Calling Number of 555, NPI of 1,
and TON of 3, the modified number becomes 13555. This number
can later be used for manipulation and routing.
Note: The parameter is applicable only to digital interfaces.
Determines whether NPI and TON are added to the Called Number
for Tel-to-IP calls.

[0] No = (Default) Do not change the Called Number.

[1] Yes = Add NPI and TON to the Called Number of ISDN Tel-
to-IP call.
For example: After receiving a Called Number of 555, NPI of 1 and
TON of 3, the modified number becomes 13555. This number can
later be used for manipulation and routing.
Note: The parameter is applicable only to digital interfaces.
Determines whether the NPI and TON values are added as the
prefix to the Redirect number in INVITE messages' Diversion or
History-Info headers, for ISDN Tel-to-IP calls.

[0] Yes (Default)

[1] No
Note: The parameter is applicable only to digital interfaces.
Determines whether or not the device removes the prefix, as
configured in the IP-to-Tel Routing table (see ''Configuring IP-to-Tel
Routing Rules'' on page 520) from the destination number for IP-to-
Tel calls, before sending it to the Tel.

[0] No (default)

[1] Yes
For example: To route an incoming IP-to-Tel call with destination
number "21100", the IP-to-Tel Routing table is scanned for a
matching prefix. If such a prefix is found (e.g., "21"), then before
the call is routed to the corresponding Trunk Group, the prefix "21"
is removed from the original number, and therefore, only "100"
remains.
Note:

The parameter is applicable only if number manipulation is
performed after call routing for IP-to-Tel calls (i.e.,
1227
65. Configuration Parameters Reference
Description
Mediant 1000B Gateway & E-SBC