AudioCodes Mediant 1000B User Manual page 1123

User's Manual
Parameter
[NotificationIPGroupID]
MWI Notification Timeout
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-ntf-
timeout
[MWINotificationTimeout]
configure voip > gateway dtmf-supp-
service supp-service-settings > mwi-
qsig-party-num
[MWIQsigMsgCentreldIDPartyNumber]
Digit Patterns The following digit pattern parameters apply only to voice mail applications that use
the DTMF communication method. For available pattern syntaxes, refer to the CPE Configuration
Guide for Voice Mail.
Forward on Busy Digit Pattern
(Internal)
configure voip > gateway voice-mail-
setting > fwd-bsy-dig-ptrn-int
[DigitPatternForwardOnBusy]
Forward on No Answer Digit Pattern
Version 7.2
65. Configuration Parameters Reference
applied to the message.
For example, if the 'SIP Group Name' field of the IP Group is
set to "company.com", the device sends the following
SUBSCRIBE message:
SUBSCRIBE sip:company.com...
Instead of:
SUBSCRIBE sip:10.33.10.10...
Note: If the parameter is not configured, the MWI
SUBSCRIBE message is sent to the MWI server as defined
by the MWIServerIP parameter.
Defines the IP Group ID to which the device sends SIP
NOTIFY MWI messages.
Note:

This is used for MWI Interrogation. For more information
on the interworking of QSIG MWI to IP, see Message
Waiting Indication on page 586.

To determine the handling method of MWI Interrogation
messages, use the
TrunkGroupSettings_MWIInterrogationType, parameter
(in the Trunk Group Settings table).
Global parameter defining the maximum duration (timeout)
that a message waiting indication (MWI) is displayed on
endpoint equipment (phones' LED, screen notification or
voice tone).
You can also configure the feature for specific calls, using
Tel Profiles (TelProfile_MWINotificationTimeout). For a
detailed description of the parameter or for configuring the
feature in the Tel Profiles table, see Configuring Tel Profiles
on page 459.
Note:

The parameter is applicable only to FXS interfaces.

If the feature is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls
associated with the Tel Profile.
Defines the Message Centred ID party number used for
QSIG MWI messages. If not configured (default), the
parameter is not included in MWI (activate and deactivate)
QSIG messages.
The valid value is a string.
Defines the digit pattern used by the PBX to indicate 'call
forward on busy' when the original call is received from an
internal extension.
The valid range is a 120-character string.
Defines the digit pattern used by the PBX to indicate 'call
1123
Description
Mediant 1000B Gateway & E-SBC