AudioCodes Mediant 1000B User Manual page 1194

Parameter
Stutter Tone Duration
configure voip > gateway dtmf-
supp-service supp-service-settings
> sttr-tone-duration
[StutterToneDuration]
FXO AutoDial Play BusyTone
configure voip > gateway analog
fxo-setting > fxo-autodial-play-
bsytn
[FXOAutoDialPlayBusyTone]
Hotline Dial Tone Duration
configure voip > gateway dtmf-
supp-service dtmf-and-dialing >
hotline-dt-dur
[HotLineToneDuration]
Reorder Tone Duration
configure voip > gateway analog
fxo-setting > reorder-tone-duration
[TimeForReorderTone]
User's Manual
after the port is seized in response to ringing (from PBX/PSTN).
The valid range is 0 to 60. The default time is 16.
Note for analog interfaces:

During play of dial tone, the device waits for DTMF digits.

The parameter is not applicable when Automatic Dialing is
enabled.
Defines the duration (in msec) of the confirmation tone. A stutter
tone is played (instead of a regular dial tone) when a Message
Waiting Indication (MWI) is received. The stutter tone is
composed of a confirmation tone (Tone Type #8), which is
played for the defined duration (StutterToneDuration) followed
by a stutter dial tone (Tone Type #15). Both these tones are
defined in the CPT file.
The range is 1,000 to 60,000. The default is 2,000 (i.e., 2
seconds).
Note:

The parameter is applicable only to FXS interfaces.

If you want to configure the duration of the confirmation tone
to longer than 16 seconds, you must increase the value of
the parameter TimeForDialTone accordingly.

The MWI tone overrides the call forwarding reminder tone.
For more information on MWI, see Message Waiting
Indication on page 586.
Determines whether the device plays a busy / reorder tone to
the PSTN side if a Tel-to-IP call is rejected by a SIP error
response (4xx, 5xx or 6xx). If a SIP error response is received,
the device seizes the line (off-hook), and then plays a busy /
reorder tone to the PSTN side (for the duration defined by the
parameter TimeForReorderTone). After playing the tone, the
line is released (on-hook).

[0] = Disable (default)

[1] = Enable
Note: The parameter is applicable only to FXO interfaces.
Defines the duration (in seconds) of the hotline dial tone. If no
digits are received during this duration, the device initiates a call
to a user-defined number (configured in the Automatic Dialing
table - TargetOfChannel - see Configuring Automatic Dialing on
page 621).
The valid range is 0 to 60. The default is 16.
Note:

The parameter is applicable to analog interfaces.

You can define the Hotline duration per FXS/FXO port using
the Automatic Dialing table.
Global parameter defining the duration (in seconds) that the
device plays a busy or reorder tone before releasing the line.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_TimeForReorderTone). For a detailed
description of the parameter and for configuring the functionality
in the Tel Profiles table, see ''Configuring Tel Profiles'' on page
459.
1194
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055