Disconnecting Active Calls; Configuring Name For Telephony Ports - AudioCodes Mediant 1000B User Manual

User's Manual
•
"Going Out Of Service (<duration remaining of graceful period> sec / <number of
calls still active> calls)": Appears when the device is locking the Trunk Group and
indicates the number of buys channels and the time remaining until the graceful
period ends, after which the device locks the channels regardless of whether the
call has ended or not.
•
"Out Of Service": All fully configured trunks in the Trunk Group are out of service,
for example, when the Trunk Group is locked or in Busy Out state (see the
EnableBusyOut parameter).
Note:
reset while graceful lock is in progress, the Trunk Group is forced to lock immediately
after the device finishes its reset.
43.4

Disconnecting Active Calls

You can forcibly disconnect all active calls, or disconnect specific calls based on Session
ID.

To disconnect calls through CLI:

Disconnect all active calls:
# clear voip calls

Disconnect active calls belonging to a specified Session ID:
# clear voip calls <Session ID>
43.5

Configuring Name for Telephony Ports

You can configure an arbitrary name or a brief description for each telephony port
displayed on the Home page. This description is displayed as a tooltip when you hover
your mouse over the port.
Note:

To add a port description:
1. Open the Monitor home page (see ''Viewing Device Status on Monitor Page'' on page
868).
2. Click the required port icon; a shortcut menu appears:
Version 7.2
If the device is reset, a locked Trunk Group remains locked. If the device is
Only alphanumerical characters can be used in the port description.
Figure 43-3: Choosing Port Description
785 Mediant 1000B Gateway & E-SBC
43. Channel Maintenance