AudioCodes Mediant 1000B User Manual page 1187

User's Manual
Parameter
is-cas-sndhook-flsh
[CASSendHookFlash]
Release Cause Mapping from ISDN to SIP Table
Release Cause Mapping
Table
configure voip > gateway
manipulation
CauseMapIsdn2Sip
[CauseMapISDN2SIP]
Release Cause Mapping from SIP to ISDN Table
Release Cause Mapping
Table
configure voip > gateway
manipulation
CauseMapSip2Isdn
[CauseMapSIP2ISDN]
ISDN-to-ISDN Release Cause Code Conversion Table
Release Cause ISDN > ISDN
configure voip > gateway
manipulation cause-map-
Version 7.2
CallTranferComplete RedirectionNumber and RedirectionName.
Note:

For IP-to-Tel calls, the RedirectionNumber and RedirectionName
in the CallTRansferComplete invoke is derived from the P-
Asserted-Identity and Privacy headers in the received SIP INFO
message.

To include the P-Asserted-Identity header in outgoing SIP
UPDATE messages, set the AssertedIDMode parameter to Add
P-Asserted-Identity.
Enables sending Wink signal toward CAS trunks.

[0] = Disable (default)

[1] = Enable
If the device receives a mid-call SIP INFO message with flashhook
event body (as shown below) and the parameter is set to 1, the
device generates a wink signal toward the CAS trunk. The CAS wink
signal is done by changing the A bit from 1 to 0, and then back to 1
for 450 msec.
INFO sip:4505656002@192.168.13.40:5060 SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To: <sip:4505656002@192.168.13.40:5060>;tag=132878796-
1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
Content-Length: 17
event flashhook
Note: The parameter is applicable only to T1 CAS protocols.
This table parameter maps ISDN Q.850 Release Causes to SIP
responses. The format of the ini file table parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_Index =
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
This table parameter maps SIP responses to Q.850 Release Causes.
The format of the ini file table parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
Defines ISDN-to-ISDN release cause code mapping rules.
The format of the ini file table parameter is as follows:
[ CauseMapIsdn2Isdn ]
1187
65. Configuration Parameters Reference
Description
Mediant 1000B Gateway & E-SBC