AudioCodes Mediant 1000B User Manual page 1028

Parameter
Delay After Reset [sec]
configure voip > sip-
definition advanced-
settings > delay-after-reset
[GWAppDelayTime]
[Mediant1000DualPowerS
upplySupported]
[GroundKeyDetection]
Port Ground Start
[GroundKeyDetection_x]
User's Manual
device exists Lifeline and operates as normal.

[0] = (Default) Lifeline is activated upon power outage.

[1] = Lifeline is activated upon power outage.

[2] = Lifeline is activated upon a power outage network failure
(logical link disconnection), or when the Trunk Group is in Busy Out
state (see the EnableBusyOut parameter).
The Lifeline (FXS) phone is connected to the following port:

FXS Port 1 of each FXS module
FXS Port 1 connects to the POTS (Lifeline) phone as well as to the
PSTN / PBX, using a splitter cable.
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.

To enable Lifeline upon network failure, the LAN Watchdog feature
must be activated (see the EnableLANWatchDog parameter).

A Lifeline phone connection can be set up for each installed FXS
module (using Port I).

For information on Lifeline cabling, refer to the Installation Manual.
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by a
DHCP server.
Enables the device to send an alarm (to the SNMP client and Web
interface) if one of the Power Supply modules is removed from the
chassis or not operating correctly (failure).

[1] = (Default) Disable - no alarm is sent.

[2] = Enable - an alarm is sent.
Note:

For the parameter to take effect, a device reset is required.

If the parameter is set to [2], for this feature to be functional, both
Main and Redundant Power Supply modules must be housed in the
chassis.

If the device is intentionally installed with only one Power Supply
module, then make sure that the parameter is set to [1]; otherwise,
an alarm will be raised.
Defines loop- or ground-start signaling for all the device's FXS and FXO
ports.

[0] = (Default) Loop-start signaling

[1] = Ground-start signaling
Note:

For the parameter to take effect, a device reset is required.

To configure the signaling method per port and for a detailed
description of this feature, see Configuring Ground- or Loop-Start
Signaling per Analog Port on page 215.
The table defines loop- or ground-start signaling per analog (FXS or
FXO) port.
1028
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055