AudioCodes Mediant 1000B User Manual page 1067

User's Manual
Parameter
Minimum Session-Expires
configure voip > sbc settings
> min-session-expires
[MinSE]
Session Expires Disconnect
Time
[SessionExpiresDisconnect
Time]
Session Expires Method
configure voip > gateway
settings > session-exp-
method
[SessionExpiresMethod]
[RemoveToTagInFailureRes
ponse]
[EnableRTCPAttribute]
[OPTIONSUserPart]
Trunk Status Reporting
Mode
Version 7.2
Note: The parameter is applicable only to the Gateway application.
Defines the time (in seconds) in the SIP Min-SE header. The header
defines the minimum time that the user agent refreshes the session.
The valid range is 10 to 100,000. The default is 90.
Note: The parameter is applicable only to the Gateway application.
Defines a session expiry timeout.
The new session expiry timeout is calculated by subtracting the
configured value from the original timeout as specified in the Session-
Expires header. However, the new timeout must be greater than or
equal to one-third (1/3) of the Session-Expires value. If the refresher
does not send a refresh request within the new timeout, the device
disconnects the session (i.e., sends a SIP BYE).
For example, if you configure the parameter to 32 seconds and the
Session-Expires value is 180 seconds, the session timeout occurs
148 seconds (i.e., 180 minus 32) after the last session refresh. If the
Session-Expires header value is 90 seconds, the timeout occurs 60
seconds after the last refresh. This is because 90 minus 32 is 58
seconds, which is less than one third of the Session-Expires value
(i.e., 60/3 is 30, and 90 minus 30 is 60).
The valid range is 0 to 32 (in seconds). The default is 32.
Defines the SIP method used for session-timer updates.

[0] Re-INVITE = (Default) Uses re-INVITE messages for session-
timer updates.

[1] UPDATE = Uses UPDATE messages.
Note:

The parameter is applicable only to the Gateway application.

The device can receive session-timer refreshes using both
methods.

The UPDATE message used for session-timer is excluded from
the SDP body.
Determines whether the device removes the 'to' header tag from final
SIP failure responses to INVITE transactions.

[0] = (Default) Do not remove tag.

[1] = Remove tag.
Enables the use of the 'rtcp' attribute in the outgoing SDP.

[0] = Disable (default)

[1] = Enable
Note: The parameter is applicable only to the Gateway application.
Defines the user part value of the Request-URI for outgoing SIP
OPTIONS requests. If no value is configured, the endpoint number
(analog) or configuration parameter 'Username' value (digital) is used.
A special value is 'empty', indicating that no user part in the Request-
URI (host part only) is used.
The valid range is a 30-character string. By default, this value is not
defined.
Enables the device to not respond to received SIP OPTIONS
messages from, and/or not to send keep-alive messages to, a proxy
1067
65. Configuration Parameters Reference
Description
Mediant 1000B Gateway & E-SBC