AudioCodes Mediant 1000B User Manual page 1259

User's Manual
Parameter
RADIUS VSA Vendor ID
configure system > radius
settings > vsa-vendor-id
[RadiusVSAVendorID]
[MaxRADIUSSessions]
RADIUS Packets
Retransmission
[RADIUSRetransmission]
RADIUS Response Time
Out
[RadiusTO]
RADIUS Accounting Parameters
RADIUS Accounting Type
configure voip > sip-
definition settings > radius-
accounting
[RADIUSAccountingType]
AAA Indications
configure system > cdr >
aaa-indications
[AAAIndications]
RADIUS User Authentication Parameters
Use RADIUS for
Web/Telnet Login
configure system > radius
settings > enable-mgmt-
login
[WebRADIUSLogin]
Password Local Cache
Mode
configure system > radius
Version 7.2
the IP Interfaces table; otherwise, RADIUS communication will fail.
Defines the vendor ID that the device accepts when parsing a RADIUS
response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
Defines the number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
Defines the number of RADIUS retransmission retries when no
response is received from the RADIUS server. See also the RadiusTo
parameter.
The valid range is 1 to 10. The default is 1.
Defines the time interval (in seconds) that the device waits for a
response before it performs a RADIUS retransmission. See also the
RADIUSRetransmission parameter.
The valid range is 1 to 30. The default is 2.
Defines at what stage of the call that RADIUS accounting messages
are sent to the RADIUS accounting server.

[0] At Call Release = (Default) Sent at call release only.

[1] At Connect & Release = Sent at call connect and release.

[2] At Setup & Release = Sent at call setup and release.
Enables the Authentication, Authorization and Accounting (AAA)
indications.

[0] None = (Default) No indications.

[3] Accounting Only = Only accounting indications are used.
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device communicates
with a user-defined RADIUS server and verifies the given username
and password against a remote database in a secure manner.

[0] Disable (default)

[1] Enable
Note:

For RADIUS login authentication to function, you must also
configure the EnableRADIUS parameter to 1 (Enable).

RADIUS authentication requires HTTP basic authentication, where
the username and password are transmitted in clear text over the
network. Therefore, it's recommended to set the HTTPSOnly
parameter to 1 to force the use of HTTPS, since the transport is
encrypted.
Defines the device's mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the
validity of the username and password (verified by the RADIUS
1259
65. Configuration Parameters Reference
Description
Mediant 1000B Gateway & E-SBC