Gateway Application Parameters; Fax And Modem Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
SBC RTCP XR Report Mode
configure voip > sip-definition
settings > sbc-rtcpxr-report-mode
[SBCRtcpXrReportMode]

65.10 Gateway Application Parameters

65.10.1 Fax and Modem Parameters

The fax and modem parameters are described in the table below.
Parameter
Fax Transport Mode
configure voip > media fax-
modem > fax-transport-mode
[FaxTransportMode]
V.21 Modem Transport Type
configure voip > media fax-
modem > V21-modem-
transport-type
[V21ModemTransportType]
V.22 Modem Transport Type
configure voip > media fax-
modem > V22-modem-
transport-type
[V22ModemTransportType]
V.23 Modem Transport Type
configure voip > media fax-
modem > V23-modem-
transport-type
[V23ModemTransportType]
Version 7.2
Enables the sending of RTCP XR reports of QoE metrics at
the end of each call session (i.e., after a SIP BYE). The RTCP
XR is sent in the SIP PUBLISH message.

[0] Disable (default)

[1] End of Call
Note: The parameter is applicable only to the SBC application.
Table 65-38: Fax and Modem Parameters
Determines the fax transport mode used by the device.

[0] Disable = transparent mode

[1] T.38 Relay (default)

[2] Bypass

[3] Events Only
Note: The parameter is overridden by the parameter IsFaxUsed. If
the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax Fallback),
then FaxTransportMode is always set to 1 (T.38 relay).
Determines the V.21 modem transport type.

[0] Disable = (Default) Transparent.

[2] Enable Bypass

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.
Determines the V.22 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.
Determines the V.23 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 423.
1107
65. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway & E-SBC