AudioCodes Mediant 1000B User Manual page 1208

Parameter
configure voip > interface fxs-fxo >
fxo-dc-termination
[FXODCTermination]
configure voip > interface fxs-fxo >
enable-fxo-current-limit
[EnableFXOCurrentLimit]
configure voip > gateway analog fxo-
setting > fxo-number-of-rings
[FXONumberOfRings]
Dialing Mode
configure voip > gateway analog fxo-
setting > dialing-mode
[IsTwoStageDial]
Waiting For Dial Tone
configure voip > gateway analog fxo-
setting > waiting-4-dial-tone
[IsWaitForDialTone]
User's Manual
Defines the FXO line DC termination (i.e., resistance).

[0] = (Default) DC termination is set to 50 Ohms.

[1] = DC termination set to 800 Ohms. The termination
changes from 50 to 800 Ohms only when moving from
onhook to offhook.
Note: For the parameter to take effect, a device reset is
required.
Enables limiting the FXO loop current to a maximum of 60 mA
(according to the TBR21 standard).

[0] = (Default) FXO line current limit is disabled.

[1] = FXO loop current is limited to a maximum of 60 mA.
Note: For the parameter to take effect, a device reset is
required.
Defines the number of rings before the device's FXO interface
answers a call by seizing the line.
The valid range is 0 to 10. The default is 0.
When set to 0, the FXO seizes the line after one ring. When
set to 1, the FXO seizes the line after two rings.
Note:

The parameter is applicable only if automatic dialing is not
used.

If caller ID is enabled and if the number of rings defined by
the parameter RingsBeforeCallerID is greater than the
number of rings defined by the parameter, the greater
value is used.
Global parameter defining the dialing mode for IP-to-Tel (FXO)
calls.
You can also configure the functionality per specific calls,
using Tel Profiles (TelProfile_IsTwoStageDial). For a detailed
description of the parameter and for configuring the
functionality in the Tel Profiles table, see ''Configuring Tel
Profiles'' on page 459.
Note: If the functionality is configured for a specific Tel Profile,
the settings of the global parameter is ignored for calls
associated with the Tel Profile.
Determines whether or not the device waits for a dial tone
before dialing the phone number for IP-to-Tel (FXO) calls.

[0] No

[1] Yes (default)
When one-stage dialing and the parameter are enabled, the
device dials the phone number (to the PSTN/PBX line) only
after it detects a dial tone.
If the parameter is disabled, the device immediately dials the
phone number after seizing the PSTN/PBX line without
'listening' for a dial tone.
Note:

The correct dial tone parameters must be configured in the
CPT file.

The device may take 1 to 3 seconds to detect a dial tone
1208
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055