AudioCodes Mediant 1000B User Manual page 396

Parameter
Query Target
query-target
[CallSetupRules_QueryTarget]
Search Key
attr-to-query
[CallSetupRules_AttributesToQuery]
Attributes To Get
attr-to-get
[CallSetupRules_AttributesToGet]
Row Role
User's Manual
with an LDAP server.

[2] Dial Plan = The Call Setup rule performs a query with
the Dial Plan.
To specify an LDAP server or Dial Plan, use the 'Query Target'
parameter (see below).
Defines one of the following, depending on the value
configured for the 'Query Type' parameter (above):

LDAP: Specifies an LDAP server (LDAP Server Group) on
which to perform an LDAP query for a defined search key.
To configure LDAP Server Groups, see Configuring LDAP
Server Groups on page 242.

Dial Plan: Specifies a Dial Plan (name) in which to search
for a defined search key. To configure Dial Plans, see
Configuring Dial Plans on page on page 735.
To configure the search key, use the 'Search Key' parameter
(see below).
Note: The parameter is applicable only if the 'Query Type'
parameter is configured to any value other than None.
Defines the key to query. For LDAP queries, the key string is
queried in the specified LDAP server. For Dial Plan queries,
the key string is searched for in the specified Dial Plan.
The valid value is a string of up to 100 characters. Combined
strings and values can be configured like in the Message
Manipulations table, using the '+' operator. Single quotes (')
can be used for specifying a constant string (e.g., '12345').
Examples:

To LDAP query the AD attribute "mobile" that has the value
of the destination user part of the incoming call:
'mobile=' + param.call.dst.user

To LDAP query the AD attribute "telephoneNumber" that
has a redirect number:
'telephoneNumber=' + param.call.redirect +
'*'

To query a Dial Plan for the source number:
param.call.src.user

Note: The parameter is applicable only if the 'Query Type'
parameter is configured to any value other than None.
Defines the attributes of the queried LDAP record that the
device must handle (e.g., retrieve value).
The valid value is a string of up to 100 characters. Up to five
attributes can be defined, each separated by a comma (e.g.,
msRTCSIP-PrivateLine,msRTCSIP-Line,mobile).
Note:

The parameter is applicable only if you configure the 'Query
Type' parameter to LDAP.

The device saves the retrieved attributes' values for future
use in other rules, until the next LDAP query or until the call
is connected. Thus, the device does not need to re-query
the same attributes.
Determines which condition must be met in order for this rule to
396
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055