AudioCodes Mediant 1000B User Manual page 1246

Parameter
SBC Fax Detection Timeout
configure voip > sbc settings > sbc-fax-
detection-timeout
[SBCFaxDetectionTimeout]
Admission Control Table
Admission Control
configure voip > sbc sbc-admission-control
[SBCAdmissionControl]
Allowed Audio Coders Table
Allowed Audio Coders
configure voip > coders-and-profiles allowed-
audio-coders <group index > coder index>
[AllowedAudioCoders]
User's Manual
Mediant 1000B Gateway & E-SBC
Description

[0] = (Default) The device replaces "sips:" with
"sip:" for the Request-URI and Contact headers
only (and retains "sips:" for all other headers).

[1] = The device replaces "sips:" with "sip:" for the
Request-URI, Contact, From, To, P-Asserted, P-
Preferred, and Route headers.
Defines the duration (in seconds) for which the device
attempts to detect fax (CNG tone) immediately upon
the establishment of a voice session. The interval
starts from the establishment of the voice call.
The valid value is 1 to any integer. The default is 10.
The feature applies to faxes that are sent immediately
after the voice channel is established (i.e., after 200
OK).
You can configure the handling of fax negotiation by
the device for specific calls, using IP Profiles
configured in the IP Profiles table (see the
IpProfile_SBCRemoteRenegotiateOnFaxDetection
parameter in Configuring IP Profiles on page 423).
Defines Call Admission Control (CAC) rules.
The format of the ini file table parameter is as follows:
[SBCAdmissionControl]
FORMAT SBCAdmissionControl_Index =
SBCAdmissionControl_AdmissionControlName,
SBCAdmissionControl_LimitType,
SBCAdmissionControl_IPGroupName,
SBCAdmissionControl_SRDName,
SBCAdmissionControl_SIPInterfaceName,
SBCAdmissionControl_RequestType,
SBCAdmissionControl_RequestDirection,
SBCAdmissionControl_Limit,
SBCAdmissionControl_LimitPerUser,
SBCAdmissionControl_Rate,
SBCAdmissionControl_MaxBurst,
SBCAdmissionControl_Reservation;
[\SBCAdmissionControl]
For more information, see ''Configuring Admission
Control'' on page 683.
Defines audio coders for the Allowed Audio Coders
Group.
The format of the ini file table parameter is as follows:
[ AllowedAudioCoders ]
FORMAT AllowedAudioCoders_Index =
AllowedAudioCoders_AllowedAudioCodersGroupNam
e, AllowedAudioCoders_AllowedAudioCodersIndex,
AllowedAudioCoders_CoderID,
AllowedAudioCoders_UserDefineCoder;
[ \AllowedAudioCoders ]
For more information, see ''Configuring Allowed Audio
1246 Document #: LTRT-27055