YASKAWA SGM7D Product Manual page 129

*3.
Refer to the following figure for the relevant locations on the Servomotor. Refer to the dimensional drawings of
the individual Servomotors for more information on tolerances.
Runout at end of output shaft
Load side
Non-load side
Concentricity between output shaft and flange outer diameter
*4.
The given values are for when the Servomotor shaft is mounted horizontally and shock or vibration is applied in
the directions shown in the following figures.
The strength of the vibration that the Servomotor can withstand depends on the application. Check the vibration
acceleration rate.
Vertical
Front to back
Shock Applied to the Servomotor
7.2.1 Small-Capacity, Coreless Servomotors: Specifications
dia.
Runout of output shaft surface
A
B
dia. Parallelism between mounting surface and output shaft surface
A
Vertical
Side to side
Vibration Applied to the Servomotor
7.2 Specifications and Ratings
: Diameter determined by motor model.
B
7
7-5