SATO PW208NX Operator's Manual page 68

Feed At P-On
Printing > Advanced > Feed At P-On
Set whether the media roll is to be fed by one sheet when the printer is powered on.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled: The printer feeds the media when it is powered on and switches to
the printing (online) screen.
Disabled: The printer does not feed the media when it is powered on and
switches to the offline (stop) screen.
Finisher Feed
Printing > Advanced > Finisher Feed
Set the media feed amount based on the print head position.
Initial setting : 0 dot
Setting range : 0 to 2040 dots
Other than 0 : The printer operates with the specified media feed amount.
0 : The printer operates with the fixed value contained in the printer.
When the 0 is set, the amount for each mode are as follows.
PW208NX :
PW208mNX:
About Finisher Feed amount
Finisher Feed refers to the moving distance from the printer head to the stop position
on each mode.
Paper End (PW208NX only)
Printing > Advanced > Paper End
Select the sensor for detecting the paper end.
Initial setting : Using I-Mark
Setting options : Using I-Mark, Using Gap
Using I-Mark: Use the I-Mark sensor (reflective type) to sense the paper
end.
Using Gap: Use the Gap sensor (transmissive type) to sense the paper
end.
Tear-Off : 88 dots
Linerless : 64 dots
Dispenser : 0 dot
Tear-Off : 66 dots
Linerless : 30 dots
Starting Up the Printer
Mobile printer PW208NX/PW208mNX
65