SATO PW208NX Operator's Manual page 27

Before You Start
• Warning Display
Icons
For details on errors, see "3.3 List of Warning Icons"
• Notifications Display
Icons
For details on notifications, see "3.4 Notifications"
For replacing the print head or platen roller, contact your SATO reseller or technical support center.
24 Mobile printer PW208NX/PW208mNX
Receive buffer near full is detected.
Available space for receive buffer is low. Wait until the icon disappears.
A command error is detected.
Indicates that the print data may be incorrect. Check the print data.
Broken element of the print head is detected.
Head error may be displayed depending on the print layout.
IP address cannot be acquired.
Perform Network connection and Network Settings again. When Network Settings are displayed
properly, restart the printer.
Authentication with iOS was interrupted.
Wait for the icon to disappear (approximately 130 seconds), then perform Authentication with iOS
again. During authentication with the iOS on process, do not power off the printer or remove the
battery.
Bluetooth connection with iOS cannot be established because of an error in the authentication
chip.
Contact your SATO reseller or technical support center.
Indicates the time to clean the printer. For setting cleaning interval, see "Notifications" of the "2.6.5

System Menu" ( page 99)
Indicates the time to change the print head or platen roller. For setting changing interval, see
"Notifications" of the "2.6.5 System Menu"
Description
(  page 138).
Description
.

( page 99).
(  page 139).