SATO PW208NX Operator's Manual page 138

Error Message
 Error
 Type of Error
Number
 Message
 Error Icon
1068 WLAN Error
Contact your SATO
reseller or technical
support center.
1069 Option Error
Contact your SATO
reseller or technical
support center.
1070 Bat. Wearing out
[Recommended]
Replace the battery
with a new one.
1071 Worn out battery
[Recommended]
Replace the battery
with a new one.
1072 Power Off Error
Use the Print /Select
button to clear an
error.
1075 NFC Error
Contact your SATO
reseller or technical
support center.
1076 NFC Command Error
Failed to reflect the
settings from the NFC.
1099 Reset
The settings are
initialized.
* : For details on error messages, see "3.1.1 Error Messages"
*
To clear the display
Press the
Power off the printer.
Press the
Or, open and close the
cover.
Press the
Or, open and close the
cover.
Press the
Press the
Press the
Press the
Causes
1) Connecting to the
button.
WLAN module
failed.
1) The Dispense,
Linerless sensors,
NFC connection
information has
been changed.
button. 1) The battery
runs out. It is
recommended that
the battery should
be replaced. The
operation time
may become short
and printing quality
may become poor.
1) The battery is
button.
degraded. Replace
the battery. The
operation time may
become short and
printing quality may
become poor.
1) The printer has
button.
not been correctly
powered off.
(The battery is
disconnected.)
1) NFC module is
button.
defective.
1) Invalid command
button.
in NFC.
1) The printer has
button.
not been correctly
powered off.
(The battery is
disconnected or
other problem
exists.)
( page 130).
Mobile printer PW208NX/PW208mNX
Troubleshooting
Countermeasures
1) Contact your
SATO technical
support center.
1) Contact your
SATO reseller or
technical support
center.
1) Replace the
battery.
1) Replace the
battery.
1) Power off the
printer, and then
remove the battery.
2) Check the
settings.
1) Contact your
SATO reseller or
technical support
center.
1) Check the
commands. When
an error cannot be
cleared, contact
your SATO reseller
or technical support
center.
1) Power off the
printer power
correctly.
2) Check the
settings.
135