SATO PW208NX Operator's Manual page 136

Error Message
 Error
 Type of Error
Number
 Message
 Error Icon
1022 Printer Overheat
Wait until the print
head temperature
decreases.
1028 GAP Not Found
Load the media
correctly.
1035 I-mark Not Found
Load the media
correctly.
1043 Low Battery
Charge the battery.
1046 EAP Auth Error (EAP
failure)
Change the settings.
1047 EAP Auth Error (EAP
timeout)
1) Check the AP and
server settings.
1050 Bluetooth Error
Contact your SATO
reseller or technical
support center.
* : For details on error messages, see "3.1.1 Error Messages"
*
To clear the display
Stop the operation of the
printer for a while.
Open and close the cover.
Open and close the cover.
Connect an AC adapter
and charge the battery so
that the low battery level
is cleared. The power is
automatically turned off
after 30 to 40 seconds.
Press the
Press the
Power off the printer.
Causes
1) The temperature
of the printer has
exceeded its
tolerance value.
1) The gap sensor
level is incorrect.
2) The sensor type is
incorrect.
3) The media is
meandering.
1) The I-mark level is
incorrect.
2) The sensor type is
incorrect.
3) The media is
meandering.
1) The battery is out
of charge.
1) The Wi-Fi settings
button.
are incorrect.
1) The Access Point
button.
(AP) setting and
authentication
server setting do
not match.
1) Bluetooth module
is defective.
( page 130).
Mobile printer PW208NX/PW208mNX
Troubleshooting
Countermeasures
1) Stop the operation
of the printer for
a while to let the
temperature of the
printer decrease.
1) Contact your
SATO reseller or
technical support
center.
2) Use the correct
sensor for the
media.
3) Clean and adjust
the media path.
1) Contact your
SATO reseller or
technical support
center.
2) Use the correct
sensor for the
media.
3) Clean and adjust
the media path.
1) Charge or replace
the battery.
1) Check the Wi-Fi
settings.
1) Check the Access
Point (AP) setting
and authentication
server setting.
1) Contact your
SATO reseller or
technical support
center.
133