SATO PW208NX Operator's Manual page 64

Receiving Level
Printing > Advanced > Calibrate > I-Mark Sensor > Receiving Level
Adjust the I-Mark sensor receiving level.
Receive : Initial value
: Setting range : 0 to 127
Slice Level
Printing > Advanced > Calibrate > I-Mark Sensor > Slice Level
Adjust the I-Mark sensor slice level.
Slice level : Initial setting
Setting range
■ Slice Level Adjustment of the I-Mark Sensor
1. Use the following formula to calculate the slice level.
(High value – Low value) ×0.7 + Low value = Slice Level
2. Select Calibrate > I-Mark Sensor > Slice Level.
3. Press the button to change the slice level. Adjust the slice level so that it
becomes the level calculated in step 1.
4. Press the button to decide the slice level.
Head Check
Printing > Advanced > Head Check
Set the head check operation.
Initial setting : All
Setting options : Off, All, Barcode
Off : Head Check disabled.
All : Check the entire print area.
Barcode : Check only the area for a printed barcode. Head check is
not applicable for barcodes printed as graphic data.
About Head Check Function
Head check is the function to check broken element of the print head automatically. If
an error occurs, printing stops. Head check is a reference for checking broken element
of the print head. This function does not guarantee barcode readability. Check barcode
readability regularly. (Failure to print does not necessarily correspond to functioning of
the head check.) Check the label printed after head error is generated by scanning the
printed barcode.
: 57
: 0.0 V(Auto)
: 0.0 V to 3.3 V
Starting Up the Printer
Mobile printer PW208NX/PW208mNX
61