SATO PW208NX Operator's Manual page 137

Troubleshooting
Error Message
 Error
 Type of Error
Number
 Message
 Error Icon
1058 CRC Check Error
Check the print data.
1059 Charging
Wait until the low battery
level is cleared.
1060 No Battery
Insert the battery.
1061 Degraded Batt.
Contact your SATO
reseller or technical
support center.
1063 Battery Error
Replace the battery.
1064 Printer Overheat
Wait until the
motor temperature
decreases.
1065 Printer Overheat
Contact your SATO
reseller or technical
support center.
1066 Paper Jam
Open the cover and
load the media again.
1067 Charging
Wait until charging is
complete.
* : For details on error messages, see "3.1.1 Error Messages"
134
Mobile printer PW208NX/PW208mNX
*
To clear the display
Press the
Stop the operation of the
printer for a while.
Insert the battery.
Replace the battery.
Power off the printer.
The power is automatically
turned off after 30 to 40
seconds.
Stop the operation of the
printer for a while.
Power off the printer.
The power is automatically
turned off after 30 to 40
seconds.
Open the cover and load
the media again.
Wait until charging is
complete.
Causes
1) CRC has not been
button.
added to the data.
2) CRC does not
match.
1) The printer is in
the low battery
status and is being
charged.
1) The battery is
disconnected.
2) The battery is not
inserted.
1) The battery is
degraded.
1) The battery is
defective.
1) The temperature
of the motor has
exceeded its
tolerance value.
1) The temperature
of the printer has
exceeded its
tolerance value.
1) The media
has jammed
during Linerless
operation.
1) You cannot power
off the printer
during charging.
( page 130).
Countermeasures
1), 2)
Check transmitted
data and interface
conditions
2) Charge the printer
so that it can
perform printing.
1), 2)
Insert the battery.
1) Replace the
battery.
1) Replace the
battery.
1) Stop the operation
of the printer for
a while to let the
temperature of the
printer decrease.
1) Stop the operation
of the printer for
a while to let the
temperature of the
printer decrease.
2) Contact your
SATO reseller or
technical support
center.
1) Open the cover
and load the
media again.
2) Power off the printer
after charging is
complete.