SATO PW208NX Operator's Manual page 20

Installing and using the charging cradle on a wall
You can set the printer on the charging cradle installed
on a wall.
When installing the charging cradle on a wall, be sure
to check the orientation so that the top and bottom
sides of the cradle are set as illustrated orientation.
Note the following when you use the printer being set on the charging cradle mounted on a wall.
• When installing the charging cradle mounted on a wall, install it vertically on a flat wall that will not
receive impact. If the charging cradle or the printer falls because of impact, it could cause an injury.
• Allow 150 mm or wider space around the charging cradle.
• To avoid injuries that may be caused by falling, attach or detach the printer with both hands.
• To prevent damage to the AC adapter, wire cables by routing them through the groove on the rear of the
charging cradle before setting the printer on a wall
Note
• Prepare the screws for you to fasten the charging cradle to a wall.
• The screws to be used for fixing the charging cradle to the wall should have both shear strength and withdrawal
strength to withstand loads of 15 Kgf (147 N) or more. You need 4 screws to install a 1Bay charging cradle, and
16 screws to install a 4Bay charging cradle (the diameter of a screw: 4.5 mm (0.2") or thicker).
• We assume no responsibility for any falling of the product that may be caused by insufficient installation strength or
a customer's carelessness or inattention.
Notes on Charging
• If the button is pressed during charging, the error below is displayed.
Error 1067 "CHARGING Wait till charging is complete."
• The power is automatically turned on when an AC adapter is connected to the printer.
• Do not remove the battery during charging. If the battery is removed during charging, the error below is displayed.
Error 1060 "NO BATTERY Please put battery."
• Even if Auto Power-Off is set to Enabled, the printer does not power off during charging.
• In the low-battery error status, printing and feeding operations cannot be performed during charging. Wait until the
low-battery error is released.
• If a battery error occurs, do not use that battery. Replace it.
• If a "No battery" error occurs with the battery installed in the printer, replace the battery. To perform internal inspections,
adjustments, and repairs, contact your SATO reseller or technical support center.
• If the printer is powered down during printing using a deteriorated battery and cannot be restarted, replace the battery.
(Rear)
Wall
.
Mobile printer PW208NX/PW208mNX
Before You Start
Cable
17