SATO PW208NX Operator's Manual page 114

Configure List
Tools > Test Print > Configure List
To perform the Configure List test print, the setting items are as follows:
1 Print
Perform the test print.
To stop the test print, press the
button.
2 Label Length Set the length of one sheet of media used for the test print.
3 Pitch Adjust the print position.
4 Offset Adjust the stop position of media.
5 Darkness Adjust Fine tune the print darkness of the print.
Notes
• The values of Label Length, Pitch, Offset and Darkness Adjust set in
the Configure List menu are reflected to the same item settings in the
BD Address menu, Factory menu, Configure QR menu and Paper
Sensor menu.
• The values of Pitch, Offset and Darkness Adjust set in the Configure
List menu are reflected to the same item settings in the Adjustment
mode ( page 63).
Initial value : 800 dot
Setting range : 400 to 1600 dots
Initial value : 0 dot
Setting range : –30 to 30 dots
Initial value : 0 dot
Setting range : –30 to 30 dots
Initial value : 50
Setting range : 0 to 99 dots
Note
0 is the lightest and 99 is the darkest.
button or
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
111