Starting Up the Printer
Configure QR
Tools > Test Print > Configure QR
To perform the Configure QR test print, the setting items are as follows:
1
Print
2
Label Length
3
Pitch
4
Offset
5
Darkness Adjust
Notes
• The values of Label Length, Pitch, Offset and Darkness Adjust set in
the Configure QR menu are reflected to the same item settings in the
BD Address menu, Factory menu, Configure List menu and Paper
Sensor menu.
• The values of Pitch, Offset and Darkness Adjust set in the Configure
QR menu are reflected to the same item settings in the Adjustment
mode
( page
112
Mobile printer PW208NX/PW208mNX
Perform the test print.
To stop the test print, press the
button.
Set the length of one sheet of media used for the test print.
Initial value
: 800 dot
Setting range
: 400 to 1600 dots
Adjust the print position.
Initial value
: 0 dot
Setting range
: –30 to 30 dots
Adjust the stop position of media.
Initial value
: 0 dot
Setting range
: –30 to 30 dots
Fine tune the print darkness of the print.
Initial value
: 50
Setting range
: 0 to 99 dots
Note
0 is the lightest and 99 is the darkest.
63).
button or