Leica LS10 User Manual page 63

Define Two Control
Points
Adjustment Results
LS10/LS15, Programs
FixPoint 1/FixPoint 2
PtClass
H1, H2

If the misclosure exceeds the closure tolerance, a warning message appears.
Press Cont to ignore the message and continue the procedure. Press Abort to
cancel the procedure and change the settings on the previous screen.
Calculated misclosure of the line at the second control point.
MisClose
Calculated closing tolerance according to the selected method.
Comp.Tol
Calculated misclosure per station.
Mis/Stn
Method that was used for the adjustment.
Method
• by Distance: the misclosure is distributed to the points of the
level line according to the distances between the staffs.
• by Station: the misclosure is distributed according to the
number of stations of the level line and is thus independent of
the distances between the staffs.
To adjust and record all points of the selected type of points, press Run.
To reset the selected points and their
heights to the default value, press Reset.
To calculate the misclosure and to view
the adjustment results, press Cont.
Select any two points of the line as first and second control
point. The default point ID is the start point of the selected
line.
Displays the type of the selected point (measured point,
fixpoint, adjusted point).
Displays the height of the selected point. If you change the
point ID, the height stored for this point ID is displayed.
For points of the type "measured", you can change the
height. Either enter the height directly or press List to select
a point with the desired height from the list of available
points.
63