Table of Contents
Advertisement
ATTACH THE REAR STABILIZER AND THE REAR HANDLE
1. Attach the rear stabilizer.
• Remove the four M8 x 20 mm Hex Socket Head Bolts (B5) and M8 x 16 mm x 1.5 mm Flat
Washers (B7) from both sides of the rear end of the Track with the 6-mm Allen Key.
• Attach the Rear Stabilizer (C) to the rear end of the rack with four M8 x 20 mm Hex Socket
Head Bolts (B5) and M8 x 16 mm x 1.5 mm Flat Washers (B7), then tighten the bolts with
the 6-mm Allen Key.
B5 (4 pcs)
Make sure you connect the parts in the same order as shown on the picture.
Make sure the bolts are tightened fully.
2. Attach the rear handle.
• Remove the four M6 x 16 mm Hex Socket Head Bolts (B9) from the Track with the 5-mm
Allen Key, as shown in the picture.
• Attach the Rear Handle (G) to the middle of the Track with four M6 x 16 mm Hex Socket
Head Bolts (B9), then tighten the bolt with the 5-mm Allen Key.
Connecting material
B7 (4 pcs)
11
Tools
6 mm
Advertisement
Table of Contents
