Fault Messages Export To External Server And Backup - Solar-Log 200 Manual

Faults

21.2.5 Fault messages Export to External Server and Backup

These messages are shown in the Status box under
Network | Backup
Fault messages export (FTP)
Error code
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
286
.
Message
The server address could
not be resolved.
Cannot open socket.
Cannot connect to the
socket.
"No response from the
server."
Wrong response from the
server.
User / password incorrect.
Wrong directory.
Unable to send the backup
file
Too many users
Log in error
Error with the remote file
names
Error when setting the
representation type.
Error when setting the
passive mode.
Socket could not be ope-
ned.
IP address could not be
changed.
Configuration | Network | Export
Possible cause or remedy
The access type was not configured. An
alternative DNS server is required. The wrong
server was entered. The network connection
was disconnected and could not be reestab-
lished.
Possible causes: Unknown. If this error conti-
nues to occur, contact our technical support.
Possible causes: The connection is blocked by
a firewall or a router. The wrong server was
entered. The server is offline.
There is a fault on the FTP server.
The FTP server used is not supported or not
configured properly.
The user name or password for FTP access
was entered incorrectly.
An incorrect directory was set for the trans-
fer.
The connection was closed. The speed was
too limited. Not enough disk space is availa-
ble.
Too many users are logged in with this ac-
count.
Unspecified log in error
This is an internal error. Contact support.
The FTP server used is not supported or not
configured properly.
Use another FTP server or check the configu-
ration.
The FTP server used is not supported or not
configured properly.
Use another FTP server or check the configu-
ration.
The connection is being blocked by a firewall
=> make the necessary firewall configurations
to allow the connection. There is a problem
with the Internet connection => check if the-
re is a problem with the settings or with the
connection in general.
This is an internal error => create a diagnosis
report from the Diagnosis | Report and send
it to support.
This is an internal error => Contact support.
Configuration |
and